DOQQs - Digital Ortho Quarter Quads

Please choose which block degree:

3088 - 3089 - 3188 - 3189 - 3190 - 3191 - 3288 - 3289 - 3290
3291
- 3388 - 3389 - 3390 - 3391 - 3488 - 3489 - 3490

or
Please choose by name:

A - B - C - D - E - F - G - H - I - J - K - L - M - N - O - P - Q - R - S - T - U - V - W - X - Y - Z

List of Quads by County

CDs of quads by county are now available. Email Steve.

LizardTech - has a free viewer that allows you to save all or part of a .sid file to geotiff format.

County DOQQ’s are now available. These images were created from the 1 meter resolution quad files and mosaiced in ERDAS Imagine to an output resolution of 3 meters. Some counties had black and white portions.  Those files are named (countyname)bw.sid (.sdw). Some counties were all black and white, this is due to the photography.  File sizes range from 1.5mb to 75mb. DOQQS's were developed from aerial photography taken during the Winters of 1995 and 1996 under US Geological Survey's (USGS) National Aerial Photography Program (NAPP).  The NAPP photographs consist of 9 x 9 inch film images scaled at 1:40,000 with each photo centered over one of the four quarters (NE,NW,SW,SE) of a USGS 7.5 minute (1:24,000) topographic map. Four individual NAPP photos are required to completely cover the area of a USGS 7.5 minute topographic map.

To produce a DOQQ, the original 1:40,000 photography is reproduced as a 1:12,000 positive print which is scanned to produce a digital file with a ground resolution of 1 meter.  These 1st order files are ortho-rectified and output as geotifs (over 150 MB each) referenced to UTM NAD83 coordinates.

The MARIS staff has mosaiced and projected the geotif files, in sets of four, to create output files in MSTM coordinates that correspond to USGS 7.5 1:24,000 topographic maps. These composite files are compressed using MrSID compression software.  The files are stored by blocks designated by degrees of latitude and longitude(for example - 3390 identifies maps with a longitude of 33 degree and longitude of 90 degrees, etc.). Individual file names follow the USGS naming scheme (3390a1c.sid, 3089g3c.sid, etc.) MrSid desiginates the image file as a .sid file with an associated .sdw file as a world geo-reference file. The .sid file is binary while the .sdw file is ASCII. These files are not available in any other format or projection from the MARIS Technical Center.

Color DOQs are designated by a "c" at the end of the file name (3389a1c.sid) while black and white DOQs are just the file name. Some quads are partial color and black and white. There will be both a .sid and c.sid file for these quads.

The reference lists below can be used to determine the file name and degree area that you need.

Most of the state is completed.  A large area of eastern Mississippi will be finished by mid-summer 2001. Check back to see if your area of interest has been completed.

If there are any general questions about DOQQs and downloading or acquiring the data through other means, please contact Steve Walker at swalker@ihl.state.ms.us or 601-432-6149.